Coax cable / Antenne plug
Menu
Coax cable / Antenne plug
The Coaxial cable was born in 1880 and is a type of electrical cable having an inner conductor surrounded by a tubular insulating layer, surrounded by a tubular conductive shield.
All coax cables also has an insulating outer sheath or jacket. A coaxial cable is a transmission line used to carry high frequency electrical signals with low loss. It is used for broadband network cabling, cable television signals and connects the radio transmitters / receivers for their antennas.
This is very important that a coaxial cable is made from high-quality materials, as 100% pure copper and that the tubular insulating material provides high isolation, and here is foam-isloator best.
it is important that a coaxial cable is as short as possible as it works signaldæmpene. A coaxial cable for radio transmitters is 50 ohms - the resistance is called impedance and should be appropriate for the radio transceiver - opposite the device (eg. An antenna) must be designed with the same resistance. Possibly. mismatch will provide reflections of the cable and destroy / interfere with signal transmission. Video Signal transmission should the impedance is 75 ohm (RG59)
A transmitter and receiver sees a coaxial cable which many complex passive components - capacity between conductor and shield, coils in series, and an ohmic resistance (loss in copper) .
a loss in a coaxial cable applies to both transmitter and receiver. A powerful coaxial cable for example. LLC400 (10mm thick) provides approximately 22dB loss per 100meters at 2.4GHz (WiFi). A LCC200 (5mm thick) gives a loss of some 100meters per 55dB at 2.4GHz. Remember to compensate Coax cable loss with passive Gain antenna if possible. Avoid any active 2-Wejs signal amplifiers.
Remember: Good quality cable offers the best connection.
There are 91 products.
Antenna adapter with N-type connector, female - female
used for collection of cables with N male
114.00 kr
Antenna adapter with N-type connector, Han-he is used eg. For direct mounting of antenna on AP
114.00 kr
Antenna connector adapter from TNC male to SMA male
Some LTE Routers have RTNCF connectors.
Transition connector for the more flexible antenna cable with SMA
Coax cables with SMA are for short lengths to minimize losses
50 OHM impedance
Standing wave ratio: 1:1.15
Frequency range: DC to 3GHz
164.00 kr
Coaksialkabel/ adapter SMA(F) til MMCX(RA) 100mm
206.00 kr
SMA adapter
nut + pin at both ends
73.00 kr
Adaptor from SMA male to SMA
Nut + rigid
Male thread + hole
73.00 kr
SMA han til N-type han RF coax adapter
Kobber/ Guldbelagt
50 Ohm
231.00 kr
SMA FEMALE TO SMA FEMALE ADAPTER
exterior thread + hole
exterior thread + hole
73.00 kr
RSMA han til SMA hun
Nut + hole
Outside thread + hole
73.00 kr
Antenna adapter
nut + hole (SMA)
exterior thread + hole (TNC)
73.00 kr
SMA adapter
exterior thread + tap
Inside thread + tap
73.00 kr
Antenna cable adapter
RSMA female to RSMA female
External thread and stud for external thread and stud
gold plated
50 ohms
139.00 kr
Low Log antenna cable WiFi, LTE, GSM
HDF400
shielded
50 ohm
N-type He to N-type Han connector
Tab: 0.22db@2.4GHz
Tab: 0.36db@5GHz
black
5 meters
427.00 kr
Antenna cable with low loss for WIFI and GSM/LTE
N-male and N-female
Loss per 10 meters at 2.4GHz: 2.2dB
Extends cable
Good and robust cable
HDF400
50 Ohms
Always vulcanize antenna joints - outdoors
Black
10 meters
754.00 kr
Low loss coax cable with N-male/male
Low loss at 10 meters: 2.2dB at 2.4GHz
LLC400, diameter approx. 1 cm
N-male to N-male
Good and robust cable
Always vulcanize joints - outdoors
Length: 1 meter
256.00 kr
Antenna cable for GSM/LTE
N-type female to SMA male (Round + pin)
LLC400 low loss cable
10 m
1,056.00 kr
Transient fuse with N-type male/N-type female connector
Up to 6GHz
Cannot protect against direct lightning strikes
Connect heavy-duty cable between the unit and the nearest ground
444.00 kr
RPTNC male to N-Type male
LLC200A
Loss per 10 meters: 5.5dB at 2.4GHz
Black
5 meters
400.00 kr
Showing 21-40 of 91 item(s)