Long-range LoRa wireless communication (non-LoRaWAN)

RS-485 MODBUS RTU protocol

1x Analog input 0–10V / 0–20mA / 4–20mA / ADC (0–10V)

1x Analog output sync-capable

1x Digital Input High/Low signal detection

1x Digital Output Supports PWM / Latch mode

AES-128/256 encrypted transmission

Rugged IP68-rated waterproof housing

Wide -40°C to 85°C operating temperature

Ideal for industrial, agricultural, and environmental IoT

Low power for remote or battery-powered deployments

Reinforcement: 8dBi
Direction: Omni-directional
Frequency range: 698-960 MHz, 1710-2170 MHz, 2300-2700 MHz
VSWR: < 2.0
Polarization: Linear Vertical
Impedance: 50 ohms
Direction: Omni-directional
Antenna connector: RP-SMA male connector
Net weight: 65g
Operating temperature: -20°С ~ +80°С
Storage temperature: -30°С ~ +85°С
Package: 2 x Antenna with 25 cm cable
NOTE: NOT FOR MPCI-E

Data, SMS Applications
Standard AT Commands
Digital Input Channel to reset the System
USB 2.0 and  RS-232
DIN-Rail
Modem sells separatly

QR8041

Dual Band 802.11ax 3000Mbps Ceiling-mount Wireless Access Point

Max. wireless speed of 2400Mbps (5GHz) & 600Mbps (2.4GHz)

Supports up to 256 simultaneous client users

2 x 10/100/1000BASE-T RJ45 port

4 x Internal 4dBi antenna (2.4G x2, 5G x2)

Modes: AP, Gateway, Repeater

WPA3 / WPA2 / WPA support

Ceiling mount

Dimensions: 185.82 x 185.82 x 36.6 mm

Supports 48V DC PoE and 12V DC input

Operating temperature range: -20 to 55°C

Weight: 380 g

Frequency: 2.4GHz / 5.8GHz
Gain: 9dBi
Connector: N-Male
Material: Fiberglass
Radiation: Omnidirectional
Length: 400mm
Impedance: 50Ω
Polarization: Linear
Beamwidth: H: 360°, V: 100/75° ±3°
IP Rating: IP67 (Waterproof)
Wind Resistance: 60m/s
S.W.R.: ≤2.0
Max Input Power: 50W
Weight: N.W 140g / G.W 230g
Color: Gray

Wifi Access Point, Bridge, Client.
2.4 GHz and 5 GHz, 802.11ac
Antenna 2x RP-SMA(M)
12-48 VDC, 6.72 W (Max), PoE PD
Operating temperature -10 - +60°C
DIN mounting
Size 47 x 110 x 90 mm

Wireless WIFI 3G / 4G Router.
Built-directional antenna to 3G/4G.
Built-in WiFi antennas.
2 x cable entry IP tight.
2 x LAN 10/100/1000 Mbps Ethernet
Power supply: 12V ~ 24V Passive PoE (POC)
18VDC / 1A Passive PoE adapter included
Downlink of 150 Mbps Uplink of 50Mbps
Mast clamp / wall
Temperature: -30 ° ~ +70°C

Outdoor robust Dual Band Access Point etc.
AP, Gateway, Repeater, Wi-Fi Mesh
2.4GHz and 5GHz, 600/2400Mbit (3000Mbit)
Up to 256 clients Wi-Fi 6
1 x RJ45 Gigabit port PoE+
IEEE 802.11ac 2T2R - Wave 2
Up to 20dBm (EIRP)
4 x N-female connector
IP67 cast aluminum housing for mast mounting
Operating temperature: -40 - +70°C
Real-time Wifi channel analyzer
Dimensions: 295 x 231 x 80 mm
Weight: 2.5kg
Supply: PoE, 48V/0.5A (PoE+)

2.4GHz, 300Mbps AP, Gateway, Repeater, Bridge, WISP
802.11 b/g/n
Includes 2 pcs. 8dBi antennas
2 x N female
Transmission power: max. 500mW
1 x 10/100Mbps RJ45
For pipe mounting and wall mounting
WPA/WPA2, WPA-PSK
IP65
Power supply: PoC or PoE+ 48VDC (injector included)
Pin 4/5 +, 7/8 - PoE input.
Operating temperature: -20 - +70°C
Dimensions: 880 x 200 x 80mm
Weight 1.7kg

300Mbps AP, Gateway, Repeater, WDS, WISP
2T2R architecture with dual-polarization 14dBi antennas built
Transmission power: 100mW
10 / 100Mbps RJ45 Kirke pipe-mounting and wall mounting
supports WAN connection for DHCP, Static IP, PPPoE
IP55
Power supply: 48VDC 0.5A (802.3at PoE +) or 12VDC 1A (via DC jack)
Operating temperature: -20 - + 70 ° C
OUTLET - OLD MODEL

2 x Wifi hardware consisting of APs antennas and power supplies
Connect 2 LAN networks between 2 buildings, wireless.
PoE supply (optional).
Lightning transient protection included - placed in the masts

5GHz, 900Mbps AP, Gateway, Repeater, Bridge, WISP
802.11 b/g/n/ac
2T2R architecture with dual-polarizing 14dBi antennas built-in
Transmission power: 100mW
2 x 10/100/1000Mbps RJ45 Ethernet
For pipe mounting and wall mounting - clamping band included
Supports WAN connection in DHCP, Static IP, PPPoE
WPA/WPA2, WPA-PSK/WPA2-PSK and 802.1X RADIUS authentication
IP55
Power supply: PoE+ (48Vdc) or 12VDC 1A (via DC jack)
Operating temperature: -20 - +70°C
Dimensions: 260 x 87 x 38 mm

Wifi AP, Client, Bridge, Repeater, Router
Industrial 2 x 2 Mimo
Qualcomm Atheros QCA9892
Supports IEEE 802.11 A / B / G / G / N / AC
2 x 10 / 100Base -Tx Wan / Lan-Port
TX Power 21 db to 2.4 GHz
TX Power 18 BB for 5GHz
WPA, WPA2, WPA3, WEP, TKIP, AES
Supply voltage: 9 ~ 48VDC In the 4-pin terminal block
protection against reverse polarity
IP30 protection
DIN rail or wall mountable
Operating temperature: 0 ° to 60 ° C
Dim: 162 x 110 x 46 mm

Indoor Access Point, Gateway, Repeater, Super WDs
Ultra High Speed ​​AP With At the Atlictor Serving Users
Access Point, Gateway, Wisp, Repeater, Super Wds
Wave 2 Technology Increases the data amount to the individual User
Dual Band: 2.4GHz (300Mbps) / 5GHz (867Mbps)
High transmission power, adjustable
1 x RJ45 LAN with PoE + input
1 x RJ45 LAN
Supply voltage at non-PoE: 12VDC / 1.5A
Power Jack DC Input connector: 5.5 / 2.1 mm
2 x 2 5dbi built-in antennas
Transmission power: 100mW
Up to 50 users (Clients)
Dim: 186 x 186 X 36 mm
Operating temperature: 0 - + 40 ° C

Wifi Uplink or Ethernet WAN connection
1 x LAN port
1 x RS232 / RS485 for Modbus RTU
1 x Digital input / 1 x Digital output
Roaming - field strength controlled
IEEE 802.11a/b/g/n/ac Wi-Fi
Supply voltage: 9 to 48 VDC
DIN rail
Operating temperature -20℃ to +60℃
Dimensions: 131 x 108 x 31 mm

WLAN up to 150Mbps (Single radio 2.4GHz)

Industrial 1x1 SISO (Single Input Single Output)

IEEE 802.11 b/g/n

2 x 10/100Base-TX WAN/LAN Port

Chipset: Qualcomm/Atheros AR9331 SoC

Tx Power (EIRP) 21 dB for 2.4GHz

5 dBi dipole antenna

WPA, WPA2, TKIP, AES

Power Input: 9 - 48VDC / 2W, 4-pin Terminal Block

Reverse Polarity Protection

IP30 sealed enclosure

DIN rail and wall mounting

Operating temperature: 0°C to 60°C

Weight: 1 kg

Dimensions: 26 x 95 x 75 mm

Industrielt 2,4/5GHz trådløst Access Point
1200Mbps 802.11ac
Dual Band
LAN Gigabit Ethernet 
1 x 10/100/1000BASE-TX RJ45 port med PoE
2 x 2.4GHz 5dBi SMA antenne, 2 x 5GHz 5dBi SMA antenne med RP-SMA-stik 
802.3at PoE, 48-56V DC input
IP30 tæt kabinet
Driftstemperatur -10 til +60°
Til vægmontering