Previous
Next
Remote control and measurement, ICMP echo req/reply Watchdog, 2xDigital in, 2xAnalog in, 2xRelay out, 1-wire sensor input
1,030.00 kr
Ekskl. moms
Module with password protected Web based configuration and control
Instant ICMP watchdog - no echo will restart the module
1-Wire interface for 2 sensors
2 x relay outputs with NO/NC contacts
2 x analog input 0 to 60VDC - 10bit resolution, 100mV display
2 x digital input with "dry contact" or "logic level" mode
Stable IP watchdog monitoring - for equipment restart
SNMP v.1 support
SNMP trap conditional messages
VLAN and MAC address filtering
Remote FTP firmware update.
Supply voltage: 10 - 14VDC - purchase PSU
Quantity
Physically in stock
Ask a question
close
TCW122B-WD is a surveillance module for monitoring IP surveillance applications, specially designed for a fail-safe surveillance system.
The module controls the functionality of devices or networks by sending or receiving ICMP echo request or ICMP echo reply, respectively.
The current relay is activated if there is no ICMP echo (ping) within a certain time. This may reboot the monitored device or the network switch/router.
TCW122B-WD has two digital and two analog inputs. These are two relays with normally open and normally closed contacts.
For all monitored parameters - temperature, humidity, analog voltage and digital input status, SNMP traps can be sent under certain conditions.
The relays can be activated remotely (WEB and/or SNMP) or automatically from the presence/absence of ping.
Andre produkter i samme kategori:
Previous
Next